Restoration of the statue of the Assumption of St. Mary – Ħal Balzan
Between Triq Santa Marija and Main Street in Balzan lies a small church dedicated to Our Lady. In front of this church stands a stone statue representing the Assumption of Mary sculpted by the sculptor Sigismondo Dimech in 1838.1 This statue was made as a vow for deliverance from the plague of the year 1837.2
The statue, carved in globigerina limestone, depicts the Virgin Mary ascending into heaven. The fact that Our Lady is bearing a crown constitutes a particular feature, since the Assumption is not usually depicted in this manner.
The statue surmounts an ornate pedestal which is subdivided into two sections. The upper pedestal section, which, viewed from street level, seems to be continuous with the statue itself (i.e. carved out from the same stone block), is very intricate and rich in sculptural and decorative motifs. The simpler, and much higher, lower section consists of a high dado, central panels framed by corner scrolls and a crowning cornice. The particular setup, and noticeable difference in stylistic approach between the lower and upper section of the pedestal, seems to suggest that the statue (including its contiguous pedestal section) could have been designed for somewhere else and subsequently mounted in its current location on the lower pedestal. The base of the statue is cordoned off by an iron railing. A decorative wrought iron bracket, supporting a lantern, is moreover fixed at the front of the pedestal.
Before this statue was created, another one stood in its place. Today that earlier statue is located in front of the church of Our Lady of the Forsaken in the area of San Ġwann.3
Restoration works
The statue of Our Lady was lowered to ground level. The statue was desalinated, consolidated and restored on site whereas individual elements of the underlying podium were transported to the RPD offices for desalination and consolidation off-site. Following completion of restoration works on the individual elements, the statue was re-assembled on site.
Upper parts of the stone corbels of the pedestal were hand carved to replace deteriorated ones. These were then fixed together using epoxy resin and fiber glass rods. Two large stones were replaced. Three new carved rosettes were made. Two fingers and some crown elements were carved and pieced in using epoxy resin and fiber rods. Both the podium and the statue were then given a fresh coat of paint. A damp proof course was inserted between the pedestal and overlying statue.
References:
- Terribile, T. (2000). Niċeċ u Statwi fit-Toroq Maltin. Kullana Kulturali. Publikazzjonijiet Indipendenza.
- Fenech, M. (2018). Il-knisja ta’ Santa Marija fĦal Balzan. Festa titulari ta Santa Marija, l-Imqabba 2018.
- Terribile T. (2000).